This article describes the Bumper Refinish Prompt and corresponding action buttons.
Bumper Refinish Prompt Settings
The below describes the “yes” and “no” response to the bumper refinish prompt in more detail.
- If the bumper refinish prompt is configured for “Do not prompt” in the CCC ONE estimating options then the user will not be prompted.
- If the bumper refinish prompt is configured to “Prompt Defaults to No” or “Prompt Defaults to Yes” then the user will be prompted with the following question when adding a bumper to an estimate: "Refinish bumper as a separate procedure from the other panels?"
Answer “Yes” if the paint system being used requires additives for the flexible components and the mix including the additives is not being used on the rigid components. If the refinish procedure utilizes a separate mix for flexible and rigid parts, and therefore, the parts cannot be refinished in a continuous process. (Note that the majority of paint systems currently in use require flex additive for flexible parts – check with a paint company representative for the requirements regarding a particular paint system).
Answer “No” if the paint system being utilized does not require a separate additive (and therefore a separate mix) to be used for flexible parts – and therefore the same mix is being used in a continuous process for both flexible and rigid parts
Answer “No” if the paint system being used allows for a mix that includes the addition of an additive to be used on both flexible and rigid parts, and the refinish process uses such a mix that includes the additive to spray both flexible & rigid parts in a continuous process.